I can't go past 140 right now and I think 200 is all the more I'd want/need. So total max current through the caps is 260 watts. The least rated part of this that I know of would be the 4 caps feeding the vrm rated at 65 watts each. Vrm is 6 phase with MOSFETs rated at 45amp each. Cpu power is off of 2 18amp psu rails and uses a 10 pin eps plug. I've done cooling mods to the cpu and vrm. I just cannot identify how it is sensing current.ģ if anyone just has access to schematics for this board I'll stare at them until I figure it out. If anyone has info on doing this I have the schematics for the vrm controller and the MOSFETs. I have the board out, a couple fluke multi meters and soldering tools. I'd like to cut the reported current in half. If someone can successfully mod my bios either graphically or just change the "hidden" settings that would be awesome.Ģ I need to modify the current sense circuit for the vrm. I've tried modding it and a couple of people from bios mods and win raid tried modding. I have all the ami bios tools and a spi programmer. Where I'm at right now is in order from best solution to worst.ġ I need an unlocked bios. I'm at my TDP limit of 140 watts and I can't get past it. I've been overclocking it using throttle stop. So I have a Dell precision T5810 with an E5-1650v3 cpu. Hoping this is the right section to post and I have 3 questions that any one of them answered should fix me up.
0 Comments
Leave a Reply. |